The .41 Long Colt cartridge was created in 1877 for Colt's double-action "Thunderer" revolver. It was a stretched version of the earlier centerfire .41 (Short) Colt, which was made to duplicate the dimensions of the even earlier .41 Rimfire. The front of the bullet was about 0.406"-0.408”OD, the same as the case. The barrel was about 0.404”-0.406” groove diameter. The bullet lubrication was outside of the case. The base of the bullet was smaller in diameter at 0.386”-0.388"OD to fit inside the case. This is known as a "heel-base" bullet. The term Colt, when used by itself, can refer to: A firearm produced by Colts Manufacturing Company, founded by Samuel Colt. ... A US Army 45 Colt. ...

In the mid-1890’s, Colt redesigned the cartridge. They reduced the entire diameter of the bullet to 0.386"OD and lengthened the brass case in order to put both the bullet and its lubrication inside the case. The overall length of both loaded cartridges was about the same. The barrel of the revolver was reduced slightly to match the more popular 38-40 at 0.400"-0.401” groove diameter (this was probably done for manufacturing reasons, not accuracy reasons). This meant that the outside diameter (OD) of the new bullet was smaller than the barrel’s bore, let alone its groove diameter. A hollow-base bullet can be dropped down the bore by gravity alone. The newer soft lead bullet was made with a large hollow base, like Civil War Minié balls. The intent was for the base of the bullet to expand with the pressure of the burning gunpowder to grip the rifling. Combatants United States of America (Union) Confederate States of America (Confederacy) Commanders Lincoln, President Ulysses S. Grant, General Jefferson Davis, President Robert E. Lee, General Strength 2,200,000 1,064,000 Casualties 110,000 killed in action, 360,000 total dead, 275,200 wounded 93,000 killed in action... 1855 minie ball design from Harpers Ferry, West Virginia The Minié ball (or minie ball) is a type of muzzle-loading rifle ordnance named after its main co-developer, Claude-Étienne Minié. It came to prominence in the Crimean War and American Civil War. ...

The original 41LC brass cases came in three primary lengths, although they vary quite a bit within a headstamp. The first ones were the shortest at about 0.932” to 0.937” long. In balloon-head cases, they held about 20gr of compressed black powder (BP) with a 200gr flat-bottom, heel-base, blunt-nose bullet. The next cases were about 1.130” to 1.138” long with a 200gr hollow-base, blunt-nose bullet and about 21gr of BP (also in balloon-head cases). Although the brass case lengths were far different, both cartridges were about the same overall length when loaded. The last brass case length was 1.050” to 1.100” long and was created exclusively for hand loaders so that both heel-base and hollow-base bullets could be used interchangeably (note that cartridges made from the longest brass cases and heel-base bullets are too long to fit most 41LC revolvers). Black powder for sporting can be freely bought in Switzerland. ...

The .41 Long Colt worked surprisingly well considering the mismatch of bullet and bore sizes, but by the beginning of WWI it was in serious decline and it was dead by the beginning of WWII. The accuracy the 41LC is capable of is not good enough for a target or a hunting gun, but it is certainly adequate for what it was intended; close range self defense. In fact, Elmer Keith wrote in his book "Sixguns" that the 41LC was a better fight-stopper than its paper ballistics would indicate and it was better for self-defense than any .38 Special load made. Elmer Keith (March 8, 1899 – February 12, 1984) was an Idaho rancher, highly influential firearms enthusiast, and author. ... . ...