FACTOID # 82: The women of Iceland earn two-thirds of their nation's university degrees.
 
 Home   Encyclopedia   Statistics   Countries A-Z   Flags   Maps   Education   Forum   FAQ   About 
 
 
 
WHAT'S NEW
RECENT ARTICLES
More Recent Articles »
 

SEARCH ALL

FACTS & STATISTICS    Advanced view

Search encyclopedia, statistics and forums:

 

 

(* = Graphable)

 

 


Encyclopedia > Cut (cards)

After a deck of cards is shuffled by the dealer, it is often given to a player other than the one who performed the shuffle for a procedure called a cut. The riffle Shuffling is a procedure used to randomize a deck of playing cards to provide an element of chance in card games. ...

Contents

Procedure

The dealer completes their shuffle, and then sets the cards face-down on the table near the designated player, typically the player to the dealers right. The player cuts the deck by removing a contiguous range of cards from the deck, and places them toward the dealer. The simplest form of the cut is done by taking, roughly, the top one-half of the cards, and placing them on the table or a cut card. Either the player cutting or the dealer then completes the cut by placing the remaining bottom portion on top of the cards that have been cut off.


Once the cut is complete, the dealer then picks up the deck, straightens or "squares" it, then deals the cards.


Etiquette

The continuous section may also be taken from the middle of the deck. This is called Scarne's Cut, though in some settings this is considered poor etiquette or against the rules. A cut involving a very small number of cards, such as taking only the top card as a cut, is often acceptable...especially according to "House" rules. The same is true when a player takes every top card save for one on the cut. There is no known rule that states this type of cut is not legitimate. Proper etiquette for a standard cut is for the player to the dealer's right to remove a contiguous pile of six or more cards and place it closer to the dealer than the original pile. The dealer then places the pile furthest from him on top of the cut pile. Placing the cut cards toward the dealer ensures that the cards are placed in the proper order if the dealer did not see the cut.


During informal card games, the dealer is typically not required to offer the cut, and even if offered, the designated player can decline the request. On the other hand, any player may specifically request to cut the cards before they are dealt. If a cut is requested by a player, it must be granted by the dealer. // For the game on The Price Is Right, please see Card Game (pricing game). ...


In formal player dealt settings, such as in a casino or during a tournament, an offer to cut the deck is mandatory and the designated player must perform the cut. When the dealer is not a player (i.e. a casino employee), the cut is mandatory and is usually performed by the dealer.


A cut should always be completed with one hand to limit possibility of a false cut.


Scarne's Cut

Scarne's cut was developed by John Scarne during WWII to help protect servicemen against cheating by unscrupulous dealers. Pull out a portion of the middle of the stack and then place back on top of the deck. Then perform a regular cut described earlier.


Reasons

The practice of cutting is primarily a method of reducing the likelihood of someone cheating by manipulating the order of cards to gain advantage. Even if the dealer does not plan on cheating, cutting will prevent suspicions, thus many rules require it. Some players also consider the cut to be lucky. A four leaf clover is often considered to bestow good luck This article is about fortune. ...


As a game

Cutting cards is usually a prelude to a game, but it can be a game unto itself. Each player, in turn, removes a selection of cards from the top and reveals the bottom card to all the players, and then replaces the cards in the original position. Whoever has revealed the highest (or sometimes lowest) card is the winner. This is often used in an informal setting, much like flipping coins.


See also


  Results from FactBites:
 
Membership Cards Only - We manufacture membership cards, phone cards and direct mail packages that include membership ... (890 words)
Card position on the form - if the elevated card substrate is too close to the pull wheels, the form may skew in the printer (be careful to know whether the laser is pulling from the long edge or the short edge).
Card position on the form is even more critical than when using cut cards - if the card is too close to the pull wheels, the form may skew in the printer and cause it to jam.
Card position on the form is critical - if the laminated card is too close to the pull wheels, the form may skew in the printer (be careful to know whether the laser is pulling from the long edge or the short edge).
Cut (cards) - Wikipedia, the free encyclopedia (630 words)
After a deck of cards is shuffled by the dealer, it is often given to a player other than the one who performed the shuffle for a procedure called a cut.
The simplest form of the cut is done by taking, roughly, the top one-half of the cards, and placing them on the table or a cut card.
Proper etiquette for a standard cut is for the player to the dealer's right to remove a contiguous pile of six or more cards and place it closer to the dealer than the original pile.
  More results at FactBites »


 
 

COMMENTARY     


Share your thoughts, questions and commentary here
Your name
Your comments

Want to know more?
Search encyclopedia, statistics and forums:

 


Lesson Plans | Student Area | Student FAQ | Reviews | Press Releases |  Feeds | Contact
The Wikipedia article included on this page is licensed under the GFDL.
Images may be subject to relevant owners' copyright.
All other elements are (c) copyright NationMaster.com 2003-5. All Rights Reserved.
Usage implies agreement with terms, 1022, m