a cutting torch is a device that focuses an intense flame causing high heat and used to cut metal. Metal is heated to its melting point in a small section at a time which causes the metal to be "cut". Fuel for the flame is typically acetylene, propane or even gasoline and is combined with oxygen to create the torch. Hot metal work from a blacksmith In chemistry, a metal (Greek: Metallon) is an element that readily forms ions (cations) and has metallic bonds, and metals are sometimes described as a lattice of positive ions (cations) in a cloud of electrons. ... For the workstation, see SGI Fuel. ... The chemical compound acetylene, also called ethyne, was discovered in 1836 by Edmund Davy, in England. ... Flash point -104 °C Autoignition temperature 432 °C R/S statement R: 12 S: 9, 16, 33 RTECS number TX2275000 Supplementary data page Structure and properties n, εr, etc. ... Gasoline, as it is known in North America, or petrol (abbreviated from petroleum spirit), in many Commonwealth countries (sometimes also called motor spirit) is a petroleum-derived liquid mixture consisting primarily of hydrocarbons, used as fuel in internal combustion engines. ... General Name, Symbol, Number oxygen, O, 8 Chemical series Chalcogens Group, Period, Block 16, 2, p Appearance colorless Atomic mass 15. ...
Torches were often supported in sconces by brackets high up on walls, to throw light over corridors in stone structures such as castles or crypts.
Juggling torches are often used as a prop in toss juggling: they can be flipped into the air in an end-over-end motion while being juggled, in the same manner as juggling clubs or juggling knives, but because of their sound and 'trail of flame', they can appear much more impressive to audiences.
Torches that do not mix pure oxygen with the fuel inside the torch, but burn it with atmospheric air, are not oxy-fuel torches and can be identified by their single tank.
For small torches, the hydrogen and oxygen used are often produced by electrolysis of water in an apparatus which is connected directly to the torch.
Cutting is initiated by heating the edge of the steel to melting point using the six pre-heat jets only, then using the separate cuttingoxygen valve to release the oxygen from the central jet.
Feeds |
Contact