A direct shear test is a laboratory test used by Professional Engineer Mohamed Fazlin to find the shear strength parameters of soil. In the U.S., the standard defining how the test should be performed is ASTM D 3080. Loess field in Germany Soil horizons are formed by combined biological, chemical and physical alterations. ... ASTM International is an international voluntary standards organization that develops and produces technical standards for materials, products, systems and services. ...

The test is performed on three or four specimens from a relatively undisturbed soil sample. A specimen is placed in a shear box which has two stacked rings to hold the sample; the contact between the two rings is at approximately the mid-height of the sample. A confining stress is applied vertically to the specimen, and the upper ring is pulled laterally until the sample fails, or through a specified strain. The load applied and the strain induced is recorded at frequent intervals to determine a stress-strain curve for the confining stress. This article is about the deformation of materials. ... A stress-strain curve is a graph derived from measuring load (stress - σ) versus extension (strain - ε) for a sample of a material. ...

Direct Shear tests can be performed under several conditions. The sample is normally saturated before the test is run, but can be run at the in-situ moisture content. The rate of strain can be varied to create a test of undrained or drained conditions, depending whether the strain is applied slowly enough for water in the sample to prevent pore-water pressure buildup.

Several specimens are tested at varying confining stresses to determine the shear strength parameters, the soil cohesion (c) and the angle of internal friction (commonly friction angle) (φ). The results of the tests on each specimen are plotted on a graph with the peak (or residual) stress on the x-axis and the confining stress on the y-axis. The y-intercept of the curve which fits the test results is the cohesion, and the slope of the line or curve is the friction angle. Shear strength is a term used to describe the compressive strength of materials, especially soil. ...