|
A flashover is the near simultaneous ignition of all combustible material in an enclosed area. For other uses see fire (disambiguation). ...
Flashover occurs when the majority of surfaces in a space are heated to the point (known as fire point) at which they give off flammable gases that are hot enough to sustain combustion. Flashover normally occurs at 500 °C (930 °F) for ordinary household combustibles. For other uses, see Heat (disambiguation) In physics, heat, symbolized by Q, is energy transferred from one body or system to another due to a difference in temperature. ...
The fire point of a substance is the temperature at which it will combust and continue to burn of its own accord, that means the evaporation rate is high enough so new vapor-air mixture is produced at least at the same rate as it is burned. ...
Simple sketch of pyrolysis chemistry Pyrolysis usually means the chemical decomposition of organic materials by heating in the absence of oxygen or any other reagents, except possibly steam. ...
The classic example of flashover is where a piece of furniture is set alight in a domestic room. The fire on the furniture produces a layer of hot smoke across the ceiling in the room. The radiated heat from this layer causes pyrolysis (heating of the other surfaces in the room, causing them to give off flammable gases). When the surface temperatures become high enough, these gases ignite and, in the space of a few seconds, every surface in the room may be on fire. For the UK band, see Furniture (band). ...
This article does not cite any references or sources. ...
“Radiant heat†redirects here. ...
Simple sketch of pyrolysis chemistry Pyrolysis usually means the chemical decomposition of organic materials by heating in the absence of oxygen or any other reagents, except possibly steam. ...
When the phenomenon occurs in open air, it is called a firestorm. This article does not cite its references or sources. ...
Different types of flashover
The original Swedish terminology related to the term 'flashover' has been altered in its translation to conform with current European and North American accepted scientific definitions as follows: - A lean flashover (accepted scientific terminology is ROLLOVER) is the ignition of the gas layer under the ceiling, leading to total involvement of the compartment. The fuel/air ratio is at the bottom region of the flammability range.
- A rich flashover occurs when the flammable gases are ignited while at the upper region of the flammability range. This can happen in rooms where the fire subsided because of lack of oxygen. The ignition source can be a smouldering object, or the stirring up of embers by the air track. The internationally accepted scientific definition of such an event is known as 'backdraft'.
- A delayed flashover occurs when the colder gray smoke cloud ignites after congregating outside of its room of origin. The results can be very unpredictable, and if the ignition occurs at the ideal mixture, the result can be a violent smoke gas explosion. The internationally accepted scientific terms for this process are either smoke explosion or fire gas ignition depending on the severity of the combustion process.
- A hot rich flashover occurs when the hot smoke with flammable gas ratio above the upper limit of flammability range and temperature higher than the ignition temperature leaves the compartment. Upon dilution with air it spontaneously ignites and the resultant flame can propagate back into the compartment, resulting in an event similar to a rich flashover. The internationally accepted definition of this process is known as auto-ignition which is another form of fire gas ignition.
Smoldering (or smouldering in British spelling) is slow combustion without generating flame, barely spreading. ...
Dangers of flashovers Flashover is one of the most-feared phenomena among firefighters. Firefighters are taught to recognize flashovers and avoid backdrafts. For example, they have certain routines for opening a closed door in a building on fire, such as sitting beside the door instead of in front of it, and to be ready to fight shooting flames. A Canadian firefighter A firefighter or fireman is trained and equipped to extinguish fires. ...
A backdraft is a situation which can occur when a fire is starved of oxygen; consequently combustion ceases but the fuel gases and smoke remain at high temperature. ...
Despite superior protective gear, a firefighter has less than two seconds to evacuate a room that has a flashover. A Canadian firefighter A firefighter or fireman is trained and equipped to extinguish fires. ...
Flashover indicators These are some of the signs firefighters are looking for, when they attempt to determine whether a flashover is plausible. - If the room is closed or mostly closed, so the oxygen of the room has been consumed, a flashover is plausible. Flashovers in open air are very rare.
- "Rollover" or tongues of fire appear (known as "Angel Fingers" to firefighters).
- A rapid build up of heat is generally the best indication of a flashover.
Firefighters memorize a chant while in training "Thick dark smoke, high heat, rollover, free burning." So they memorize the four signs of a flashover. Rollover is a stage of a structure fire when fire gases in a room or other enclosed area ignite. ...
The color of the smoke is often considered too, but there is no connection between the color of the smoke and the risk of flashovers. Traditionally black, dense smoke was considered particularly dangerous, but history shows this to be an unreliable indicator. For example, there was a fire in a rubber mattress factory in London in 1975, which produced white smoke. The white smoke wasn't considered dangerous, so firefighters decided to ventilate, which caused a smoke explosion and killed two firefighters. The white smoke from the pyrolysis of the rubber turned out to be extremely flammable. This does not cite any references or sources. ...
A pillow top queen-size mattress. ...
This article or section does not cite any references or sources. ...
This article is about the capital of England and the United Kingdom. ...
Year 1975 (MCMLXXV) was a common year starting on Wednesday (link will display full calendar) of the Gregorian calendar. ...
In firefighting, ventilation refers to the tactic of creating a draft with an opening above or opposite the entry point so that heat and smoke will be released, permitting the firefighters to find and attack the fire. ...
See also A backdraft is a situation which can occur when a fire is starved of oxygen; consequently combustion ceases but the fuel gases and smoke remain at high temperature. ...
This article does not cite its references or sources. ...
The Sofa Super Store burns shortly after the roof collapsed with nine firefighters trapped inside. ...
External links - Living Room Flashover Video
- Rapid Fire Progress & Flashover related fire development
- Realistic hot fire training to deal safely with flashover and backdraft
- Flashover / Backdraft training
| 
Feeds |
Contact