FACTOID #53: If you thought Antarctica was inhospitable, think again - its land area is only ninety-eight percent ice. Reassuringly, the other 2% is categorised as "barren rock".
Subdivision is the process of subdividing something, usually land, into smaller pieces. A subdivision is one of these pieces. Often, the local government will require that a surety bond is in place to begin work on a subdivision. The bond is required to guarantee completion of the job. Some obligees will allow the principal to obtain other forms of gurantee including: Irrevocable Letter of Credit (ILOC), Tripartite Agreements, or Certificates of Deposit (CDs).
Subdivision is the act of dividing up land into smaller pieces that are easier to sell, usually via a plat. ... Subdivision is the act of dividing up land into smaller pieces that are easier to sell, usually via a plat. ... Subnational entity is a generic term for an administrative region within a country — on an arbitrary level below that of the sovereign state — typically with a local government encompassing multiple municipalities, counties, or provinces with a certain degree of autonomy in a varying number of matters. ... The word bond refers to anything that binds, fastens, or restrains. ...
Subdivision is defined as the division of a lot, tract, or parcel of land into 2 or more lots, plats, sites, or other divisions of land for the purpose, whether immediate or future, of sale, rent, lease, condominium conveyance or building development.
The current subdivision regulations have been revised to be consistent with RSA 674:36.
Among other factors, the Planning Board has authority to provide against scattered or premature subdivision of land, provide for harmonious development, provide for proper arrangement and coordination of streets, and regulate that land shall be of such character that it can be used for building purposes without danger to health.
Subdivision surfaces are a way to describe a surface using a polygonal model.
Subdivision surface schemes allow you to take the original polygonal model and produce an approximation of the surface by adding vertices and subdividing existing polygons.
The point of using a subdivision model is that you have that ideal limit surface at which you can always throw more and more polygons as you get closer and closer to, no matter how high the display resolution or how close the model is to the screen.
Feeds |
Contact